Skip to content

Whole-house repipe before wall close-up checklist

A pre-cover whole-house repipe checklist for approved material and sizing, fixture branches, manifolds and shutoffs, support and expansion, protection plates, fireblocking, insulation and freeze protection, pressure and leak testing, abandoned piping, grounding implications, permits, and comprehensive as-built photographs.

6 items to check

Inspection progress0 of 6
0%

Pipe material, sizing, fittings, and fixture branches match the approved system

Critical item

The selected system should support demand, pressure, temperature, compatibility, and local requirements.

Fixture shutoffs, manifolds, isolation zones, recirculation, and dead legs are controlled

Critical item

The owner should be able to isolate serviceable areas and avoid unnecessary stagnation or delay.

Piping is supported and allows approved movement without noise or abrasion

Critical item

Clamps, sleeves, bend radius, expansion loops, and isolation should follow the system instructions.

Nail plates, fireblocking, air sealing, insulation, and freeze protection are complete

Critical item

Piping should be protected from future fasteners and environmental damage while required assemblies are restored.

Pressure and leak tests pass and abandoned piping is safely disconnected or identified

Critical item

New work should pass the applicable test before concealment and old piping should not create hidden cross-connections or leaks.

Complete route photos, labels, inspection approval, and close-up release are saved

Future owners and trades should be able to locate concealed piping.

Use after new supply piping is installed and tested but before walls, ceilings, floors, insulation, or cabinets conceal it. Do not enter contaminated, structurally unsafe, energized, confined, or oxygen-deficient areas; do not open pressurized systems or handle sewage. Use qualified plumbing, electrical, remediation, environmental, and structural professionals where applicable.

Reference standards

  • Approved plumbing or restoration scope, adopted state and local plumbing, mechanical, electrical, building, and health requirements, permit and inspection conditions, authority having jurisdiction requirements, water-utility rules, and exact equipment, piping, drainage, waterproofing, and drying-system manufacturer instructions
  • Approved repipe plan, piping-system design and installation instructions, fixture demand, pressure data, and required test procedure

    • Tools

  • Written scope, fixture or equipment data, piping plan, permit, inspection records, and authorized changes
  • Camera, flashlight, dry towels, owner-safe water observations, and qualified trade test records
  • Pressure, temperature, drainage, sewer-camera, moisture, drying, and commissioning records produced with suitable instruments

    • Related Checklists

    Main water shutoff, pressure regulator, and expansion control checklist

    A residential water-service checklist for main shutoff replacement, pressure-reducing valve orientation and setting, bypass and strainer conditions, pressure testing, thermal expansion control, meter and utility boundaries, supports, accessibility, labeling, leak checks, and owner emergency operation.

    Water-damage drying before drywall and flooring rebuild checklist

    A restoration hold-point checklist for source correction, water category and hazards, material removal, containment, cleaning, structural and electrical safety, moisture mapping, drying equipment, daily records, hidden cavities, HVAC contamination, dry-standard comparison, odor and visible contamination, and authorization before drywall, cabinets, insulation, paint, or flooring are replaced.

    Water-heater replacement before startup checklist

    A pre-startup residential water-heater checklist for correct fuel and capacity, location and clearances, pan and drainage, thermal expansion, temperature and pressure relief discharge, venting or combustion air, electrical or gas connection, seismic or structural support, piping, shutoffs, permits, and leak readiness.

    Heat-pump water-heater installation checklist

    A focused heat-pump water-heater checklist for room volume and airflow, ducting where used, condensate, noise, structural support, electrical circuit, thermal expansion, relief discharge, controls, operating modes, commissioning, rebates, and owner handover before final acceptance.

    All checklists in category «Plumbing, sewer, and water damage»