Inspección de Calefacción por Suelo Radiante

1. Verify pressure test was performed before covering tubing (should maintain pressure for 24 hours)

2. Check manifold location — must be accessible for service

3. Verify tubing spacing matches design (typically 8-12" on center)

4. Check that tubing is properly secured (no floating or shifted sections)

5. Test system operation — all zones should heat evenly

6. Check surface temperature — should not exceed 85°F (29°C) for most flooring

7. Verify thermostat controls each zone independently

8. Check for proper insulation below tubing (prevents downward heat loss)

- No pressure test before covering (can't find leaks after concrete is poured)

- Tubing spacing too wide (cold spots)

- Manifold not accessible (can't service or adjust)

- Surface temperature too high (damages wood flooring, uncomfortable)

- No insulation below (heat goes down instead of up)

- Zone control not working (can't adjust room by room)